4 In/2 Out Push Button Controller for SDS
Convenient, compact connection for small controls, system bus.
Holjeron’s Push Button Controller products for Smart Distributed Systems (SDS) provide a convenient and compact method for connecting small control panels to a system bus. Each push Button Controller supports up to 4 inputs and 2 outputs (I/O).
Further, the Push Button Controllers provide more than just a simple I/O interface to a host controller. The health of a light bulb or LED can be continuously monitored, and a diagnostic event is reported if a bulb is missing or burns out. A flash rate can be entered into the Push Button Controller to energize an output as being on solid, or on and flashing. Holjeron’s innovative bracketing for the Push Button Controllers allows them to be used with any 22,5 or 30,5 mm push button.
- 4 inputs and 2 outputs for connecting push button stations to SDS.
- Bus-powered I/O eliminates the need for separate control power.
- Outputs can be configured to flash at a settable rate by just turning on an output.
- Failed bulb detection diagnostic.
Product Datasheet
Ordering Information
Push Button Controller for SDS, 4 In/2 Out, GE CR104P
Push Button Controller for SDS, 4 In/2 Out, 22 mm
Push Button Controller for SDS, 4 In/2 Out, 30 mm
Related Products
4 Zone Powered Roller Controller for SDS
BusBlock Low Profile Digital I/O for SDS
BusBlock Sensor Input Module for SDS
2 In/2 Out MicroBlock Digital I/O for SDS
6 In/4 Out Push Button Controller for SDS
Stack Light Controller for SDS
Remote Serial Port for SDS
MicroBlock Sensor Input Module for SDS
BusBlock Analog Input Module for SDS
BusBlock Analog Output Module for SDS
BusBlock Digital I/O Module for SDS
BusBlock Frequency Input Module for SDS
BusBlock Densometer Input Module for SDS
F64 Multi-protocol Configuration Tool
Cables for SDS